Leeds heating,done properly.

There’s no one-size-fits-all figure, because several things drive the price: whether you need a combi or a system boiler, the output your home needs, how many bathrooms you have, and the condition and route of the existing pipework and flue. A like-for-like combi swap is more straightforward than converting from a tank-fed system or relocating the boiler, and extra work such as a new flue, a magnetic filter or upgraded pipework adds to the total. Rather than a vague ballpark, send a few photos of your boiler, the flue and the pipework on WhatsApp and you’ll get a fair, fixed price up front — with no surprises once we start and no pushy in-home survey.

It comes down to your hot-water demand and the size of your home. A combi heats water on demand from a single unit with no tank or cylinder, so it frees up cupboard and loft space and suits flats, terraces and smaller homes with one bathroom. A system boiler paired with an unvented cylinder stores hot water at mains pressure, which is better for larger homes with two or more bathrooms where several taps or showers might run at once and a combi would struggle to keep up. We work it out with proper BTU and heat-loss calculations based on your rooms, radiators and bathrooms, then size and recommend the right type for your home — never just the dearest.

A straightforward like-for-like combi replacement is usually a single day — drained down, the old boiler out, the new one fitted along with any system filter, flushed through, dosed with inhibitor, commissioned to the manufacturer’s Benchmark standard, tested and left clean and tidy. Jobs with more to them take longer: converting from a tank-fed system to a combi means removing the old cylinder and loft tanks and reworking the pipework, while relocating the boiler, fitting a new flue or upgrading old pipework can stretch to two days or more. When we quote from your photos we’ll tell you honestly how long your specific job should take, and roughly when the gas and water go off, so you can plan around being without heating or hot water for the shortest time possible.

Based in Leeds (LS6), we cover Leeds and the wider West Yorkshire area for boiler installation, repair, servicing, CP12s and central heating — including Headingley, Hyde Park, Burley, Horsforth, Roundhay, Chapel Allerton, Pudsey and the surrounding districts. Being genuinely local means we know the area’s housing, from the back-to-backs and Victorian terraces of the inner suburbs — which usually suit a combi — to the larger period and family homes that often need a system boiler and cylinder for proper hot-water flow. It also means we can usually get to jobs quickly, with emergency and out-of-hours call-outs when you’ve lost heat or hot water. For the right job we’re happy to travel wider Yorkshire too — send a photo on WhatsApp and we’ll confirm we can cover you and when we can come.

With us you deal directly with the Gas Safe registered engineer doing the work — no call centre, no commission salesman taking a cut, and no standard package sold from a brochure. Because the system is sized to your actual home with proper BTU and heat-loss calculations rather than upsold, you’re far less likely to end up with an oversized boiler you’ve overpaid for, one that short-cycles and wastes gas. You get a fair fixed price from photos sent on WhatsApp, local emergency and out-of-hours cover when your heating fails, and a tidy, properly-commissioned and registered job — with the work notified to building control and the manufacturer’s guarantee validated. Above all you’re dealing with someone accountable who works in your area day in, day out, not a sub-contractor you’ll never see again if something needs putting right.